To reinstall the finish set, face plate, handles and to set the thermostat temperature first you need to screw on the decorative shroud that simply goes over the flow control and screws into position. When tightening them you just want to gently nip the securing to the tiles. With the securing ring use silicone grease on the Nylon threads then tighten the screws being careful not to cross thread. Before installing the brass block back make sure that all of the O-rings are in place, then screw all 4 screws tightly. To replace a non-return valve, use a small flat headed screwdriver and put it just inside and to the side wall, you can edge a non-return valve out and to replace it simply press it back into its housing. You can check the operation of the non-return valve and remove any debris by pressing the plungers. Then remove the brass bock by unscrewing the bolts giving you access to the non-return valves. Remove the screws and pull off the housing ring. To gain access to the non-return valves you first need to remove the faceplate housing ring it is held in by 4 nylon screws. Make sure the pins are located correctly, then close the back nut on and screw in tightly. On the back of the cartridge are to locating pins which marry up to the two holes inside the brass body, so that it is in its correct orientation.
#Hansgrohe ibox valve install#
The whole cartridge will come out in one barrel, if you ever need to replace the cartridge unscrew the extension spline off the old one and install it onto the new one using an allen key. To remove the flow control cartridge you must unscrew the sleeve by loosening the back nut that holds the cartridge in place. It is a good idea to remember the orientation of the safety stop point. To remove the thermostat, first you must remove the safety stop sleeve. It is always good practice to remove the handle at the same place that you want to put it back on when you have finished the service.
If there is no hole, then it is on a quick click connector. There are two different ways that this can be fixed, If there is a hole on the handle, then there is a grub screw which you simply loosen and the handle will come off. This spacer is available in all the different shapes of valve that we do, square, soft cube and round.Identify how the handle is fixed to the splines of the iBox. For this we have a spacer measuring 22 mm in depth which can be installed in front of the tiles but behind the face plate of the shower.
The second part is if the wall is too thin and you are struggling to get the front face of the tile within the tolerances. The spacing block is installed between the iBox and the brass valve. To resolve this issue, you don't have to take the iBox out to move it within its tolerance, we have a spacing block that measures 25 mm in depth which will add 25mm onto the maximum line shown on the sticker guide located on the iBox. An example of tolerance issues is having to pack out the tiles more than you thought to get the wall straight but the tiling ends up being over the maximum depth to install the iBox. A standard installation requires a depth between 80 and 108 mm to the front face of the tile, which is indicated on the outside of the iBox as a guide.
0 kommentar(er)
